Telescope floor jack, garage jack, lifting capacity 40t/20t - 01694
2 stages telescope cylinder: 1st stage: 40t 2nd stage: 20t
This hydraulic floor jack is powered using a built-in pneumatic motor. The pneumatic engine facilitates frequent pumps in daily workshop routine. To run the pneumatic motor, a compressor is necessary which is not included in the scope of delivery. The compressed air operates the built-in pneumatic motor. This compressed air engine pumps the hydraulic oil into the cylinder.
The shunting bar can be adjusted in inclination and locked in three different positions. The button to activate the motor and lowering the jack is located at the end of the bar. If you turn clockwise, the cylinder will rise. By turning anti-clockwise, the cylinder will lower.
In the cylinder there is a screwable thread with a mounting for 2 pressure pieces. The shunting bar can be folded by nearly 180°. So you can reach wide under the vehicle
Technical data:
Lifting capacity and height: 1st stage 40t: 74 mm
2nd stage 20t: 68 mm
Min. height: 150 mm
Max. stroke of the cylinder: 142 mm
2 pressure pieces: 1 x 45 mm + 1 x 75 mm: both can be put together
Max. height: 150 mm + 142 mm cylinder stroke + 45 mm pressure piece = 337 mm
Max. height: 150 mm + 142 mm cylinder stroke + 75 mm pressure piece = 367 mm
Max. height: 150 mm + 142 mm cylinder stroke + 75 mm + 45mm = 412 mm
Width of the jack: in the front area 185 mm
Width of the jack: in the rear area at the castors 270 mm
Length of the jack: 430 mm
Length of the pumping rod: 1250 mm
Castors: 2 fixed castors at the rear
Saddle: 70 mm diameter
Weight: 37 kg
Shipping weight: 41 kg
For any inquiries please don't hesitate to contact us by phone at the following number: +49 2162 / 353967.
Customer pickup is possible after consultation.